NOTE : To send Bulk emails you need to enable production access in Amzon SES , If you dont have Amazon SES production access account , Click here to Buy – Buy Amazon SES Production Access Approved Accounts with 50k Daily Limit
Step 1: Create SMTP Credentials
To send emails through the Amazon SES SMTP interface, begin by creating SMTP credentials – a user name and a password – as shown below:
- Log in to the AWS Management Console.
- Click the “SES Email Sending Service” option.
- In the left navigation bar, click the “SMTP Settings” option.
- Click the “Create My SMTP Credentials” button.
- Copy your credentials or click the “Download Credentials” button as the password will not be shown again.
Step 2: Verify An Email Address
Add and verify your email address following these steps:
- Log into the Amazon SES Console.
- Click the “Verify a New Email Address” link.
- In the “Verify a New Email Address” dialog, enter the email address you wish to send messages from and click the “Verify This Email Address” button.
- You should now receive a verification message from Amazon SES asking you to confirm that you are the owner of the email address. Click the verification link in the message.
NOTE: The verification link is only valid for 24 hours after your original request.
- Check the status of the email address in the Amazon SES Console. The status of the email address should change from “pending verification” to “verified”.
You can now use Amazon SES to send email messages from this address. To send a test email, check the box next to the verified email address, and then click the “Send a Test Email” button.
Step 3: Request Removal Of Amazon SES Restrictions
To protect customers from fraud and abuse, Amazon SES does not immediately grant unlimited Amazon SES usage to new users. A number of restrictions are initially in effect, such as only being able to send emails to and from verified email addresses and is limited to a maximum of 200 messages in every 24-hour period.
Step 4: Configure Your Application To Use Amazon SES
The final step is to configure your Bitnami application to use Amazon SES. The procedure to do this varies from application to application but typically, you will need to configure the application with the correct SMTP server information and credentials. This may be done either by directly editing application configuration files or by entering the required information using the application user interface.
